Necroneja, mitenhän nämä
Lähetetty: Ma 28.06.2010 13:51
On maalattu, kiinnostaisi itsekin tuolla tavalla maalata, onko kenelläkään aavistuksia miten tuohon tulokseen on päädytty? oudon glossy pinta näyttäisi myös olevan.
Mukana Suomen miniatyyripeliskenessä jo vuodesta 2002
https://www.sotavasara.net/keskustelu/
Tuossa vielä linkki tohon "Ferrari" necron topiciin, sieltä on aika paljon kuvia poistettu mutta muutama näkyy vielä.1 - Black base coat (well, wasn’t that obvious?)
2 - Scab red is roughly blended on to were the red will be. So leave the middle areas black.
3 - Red gore is blended on top of the scab red layer. But leave some scab red towards the middle so the transition from black to red is gradual.
4 - Blend blood red on the edges of everything but don’t follow the edges completely, I "rounded out" the corners so to speak (I think you understand what I'm trying to say if you look at the pictures)
5 - Re-do the black if you accidentaly painted to much red, otherwise if it's only a small error leave it (otherwise you might have to redo the entire procedure to cover up the black).
6 - I put on two coats of red ink diluted with water.
7 - Put on a thin layer of gloss varnish (here I feel that I must recommend Vallejos gloss varnish, it's much much better than the GW version and I used it straight out of the bottle without water in it). In this particular case I put on two layers of gloss varnish to make the surface smooth (there was a pretty rough undercoat on there widgren wink.gif).
hyvä homma, kiitos tiedosta =]Xenon kirjoitti:Me knows this. Ovat ilmeisesti Dominus Ex machinan maalaamia necroneita. Noh tässä on ainakin ohje hänen topicista hienoille punaisille necroneille. Ovat siis sen verran "vanhoja" että ei ollut gw:n washeja vielä silloin olemassakaan.
Tuossa vielä linkki tohon "Ferrari" necron topiciin, sieltä on aika paljon kuvia poistettu mutta muutama näkyy vielä.1 - Black base coat (well, wasn’t that obvious?)
2 - Scab red is roughly blended on to were the red will be. So leave the middle areas black.
3 - Red gore is blended on top of the scab red layer. But leave some scab red towards the middle so the transition from black to red is gradual.
4 - Blend blood red on the edges of everything but don’t follow the edges completely, I "rounded out" the corners so to speak (I think you understand what I'm trying to say if you look at the pictures)
5 - Re-do the black if you accidentaly painted to much red, otherwise if it's only a small error leave it (otherwise you might have to redo the entire procedure to cover up the black).
6 - I put on two coats of red ink diluted with water.
7 - Put on a thin layer of gloss varnish (here I feel that I must recommend Vallejos gloss varnish, it's much much better than the GW version and I used it straight out of the bottle without water in it). In this particular case I put on two layers of gloss varnish to make the surface smooth (there was a pretty rough undercoat on there widgren wink.gif).
http://z11.invisionfree.com/Work_In_Pro ... opic=12896
Laitoin tohon edelliseen viestiin väärän linkin vahingossa äsken. Mutta nyt on oikeaan topiciin linkki.Cadaveri kirjoitti:hyvä homma, kiitos tiedosta =]